Auto Power Off - Thermador DWHD440MFM Mode D'emploi

Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The
running time may increase slightly.
To turn intensive drying on:
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 13) and press [Start] until the display
indicates "d:00". Release both buttons
3 Press the "A" button until the display shows "d:00".
4 Press the "C" button to turn intensive drying on or off. "d:01" = ON and
"d:00" = OFF
5 Press [Start] to save setting.

Auto Power Off

To save energy, the dishwasher is turned off 1 minute after the wash cycle ends.
Auto Power Off can be adjusted from P:00 to P:02.
To change the factory setting (P:01):
1 Press the [On/Off] button.
2 Hold down the "A" button and press [Start] until the display indicates
"d:00". Release both buttons.
3 Press the "A" button until the display indicates "P:01".
4 Press the "C" button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5 Press [Start] to save the setting.
InfoLight®
An LED illuminates the floor to indicate the unit is running. If the appliance is
installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 13) and press [Start] until the display
indicates "d:00".
3 Release both buttons.
4 Press the "A" button until the display shows "1:01".
5 Press the "C" button to switch between "1:01" = ON and "1:00" = OFF
and press [Start] to save.
14