Auto Power Off - Thermador DWHD640JFM Manuel D'utilisation

Cycle Completion Signal
The cycle completion is indicated by a tone.
To change setting:
1
Open the door and press the ON/OFF button.
2
Hold down the A button and press and hold Start/Resume until the display indicates "H:00".
3
Release both buttons. The LED for the A button flashes and display indicates "H:00".
4
Press the A button until the display shows "b:02" (factory setting or your previous setting).
5
Press the C button to increase or decrease the tone "b:00" = OFF and "b:03" = loudest and press Start/Resume to save the setting
and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying result. The running time may increase slightly. Use caution if utensils are
delicate!
To change setting:
1
Open the door and press the ON/OFF button.
2
Hold down the A button and press and hold Start/Resume until the display indicates "H:00".
3
Release both buttons. The LED for the A button flashes and display indicates "H:00".
4
Press the A button until the display shows "d:00"(factory setting or your previous setting).
5
Press the C button to turn on intensive drying "d:01" = ON and "d:00" = OFF and press Start/Resume to save the setting and close the
door.
Sapphire Glow® *
The interior light comes on when the door is opened, even if the unit is powered off. When the door is closed or slightly ajar, the interior light is
off.
To change setting:
1
Open the door and press the ON/OFF button.
2
Hold down the A button and press and hold Start/Resume until the display indicates "H:00".
3
Release both buttons. The LED for the A button flashes and display indicates "H:00".
4
Press the A button until the display shows "P:00" (factory setting or your previous setting).
5
Press the C button to switch between "P:00" = ON and "P:01" and "P:02" = OFF and press Start/Resume to save the setting and close
the door.
PowerBeam® *
An LED illuminates the floor to indicate the unit is running. Do not open the dishwasher door until the LED is no longer visible on the floor.
Note: If the appliance is installed at eye-level, the LED is not visible.
To change setting:
1
Open the door and press the ON/OFF button.
2
Hold down the A button and press and hold Start/Resume until the display indicates "H:00".
3
Release both buttons. The LED for the A button flashes and display indicates "H:00".
4
Press the A button until the display shows "I:01"(factory setting or your previous setting).
5
Press the C button to switch between "I:01" = ON and "I:00" = OFF and press Start/Resume to save the setting and close the door.

Auto Power Off *

To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. This setting can be adjusted from P:00 to P:02.
To change setting:
1
Open the door and press the ON/OFF button.
2
Hold down the A button and press and hold Start/Resume until the display indicates "d:0x" (x can be any number). Release both but-
tons.
3
Hold down the A button until the display indicates "P:0x".
4
Press the C button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically after 1 minute
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5
Press Start/Resume to save the setting and close the door.
*
model dependent (see page 6)
18