Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en | 4 | EV2000 Series Wallbox Charger Installation and Operation Manual
Installation and Operation Manual
IMPORTANT SAFETY INSTRUCTIONS
` Save these Instructions.
The DC Wallbox Charger should be in-
`
stalled only by a licensed contractor and/
or a licensed electrician in accordance
with all applicable state, local, and nation-
al electrical codes and standards.
Before installing the DC Wallbox charger,
`
review this manual carefully and consult
with a licensed contractor, licensed electri-
cian and trained installation expert to en-
sure compliance with local building prac-
tices, climate conditions, safety standards
and state and local codes.
WARNING! Danger of electrical shock or
injury. Turn OFF power at the panel board
or load center before working inside the
equipment or removing any component.
Do not remove circuit protective devices
or any other component until the power is
turned OFF.
CAUTION TO AVOID DAMAGE TO THE
CHARGER OR PERSONAL INJURY, MAKE
SURE THE INSTALLATION LOCATION IS
ABLE TO SUPPORT THE WEIGHT OF THE
CHARGER.
4.0 Installing the DC Wallbox
Charger
4.1 Preparation
1.
Release the screws on the crate (two sides) with a
No. 8 socket wrench.
2.
Open top lid of plywood crate.
3.
Take out mounting template.
579604 | REV. C | June 2020
4.
Cut off cable ties to move the charging plug.
5.
Remove top foam, open plastic bag, and take out the
unit.
NOTE: Carefully place the unit and the charging plug
on the ground or a flat surface at this stage.
4.2 Wall Mounting
1.
Use template and water leveler to mark out the
mounting position.
Bosch Automotive Service Solutions Inc.
Publicité
Chapitres
Table des Matières
