Table des Matières
Publicité
5. Arrange the bunches according to size from thickest to the thinnest
conductive cushions.
6. Si un passe-câbles doit servir à introduire plusieurs câbles, appliquez du Loctite 5221
sous le passe-câbles pour assurer son étanchéité (référence 25551).
6. If more than one cable go through a grommet, seal the grommet by
￭
Cheminement des câbles de commande à l'intérieur de l'armoire
5221 (catalogue number 25551) inside the grommet.
Le schéma ci-dessous illustre le cheminement des câbles de commande en taille R9. Les
câbles cheminent de la même manière en tailles R6, R7 et R8.
Routing the control cables inside the cabinet
Use the existing trunking in the cabinet wherever possible. Use sleeving
against sharp edges. When running cables to or from the swing-out fram
slack at the hinge to allow the frame to open fully.
Connecting to the inverter control unit (A41)
Connect the conductors to the appropriate terminals (see page 127) of
terminal block X504 (option +L504).
Connect the inner twisted pair shields and all separate grounding wires
clamps below the control unit.
The drawing below represents a drive with additional I/O terminal block
Without the block, the grounding is made the same way.
Notes:
•
Do not ground the outer shield of the cable here since it is grounded
through.
•
Keep any signal wire pairs twisted as close to the terminals as poss
wire with its return wire reduces disturbances caused by inductive c
Raccordements 93
Publicité
Table des Matières
