Safety Instructions; General; Operation - Reely ROAD 23 66 30 Notice D'emploi



5. Safety instructions

The guarantee/warranty will be void if damage is incurred resulting from non-compliance with
these operating instructions. We assume no liability for any consequential damage!
We do not assume any liability for damage to property or personal injury caused by improper use
or the failure to observe the safety instructions! In such cases the warranty/guarantee is voided.
Normal wear and tear during operation (e.g. worn tyres) is excluded from the guarantee and warrantee,
the same applies to accidental damage (e.g. broken control arm, scratched or destroyed vehicle body
etc.).
Dear Customer, the following safety instructions are intended not only for the protection of the product, but
also for your own safety and the safety of others. This is why you should read this section very carefully
before using the product!
a) General
Caution, important note!
Operating the model can lead to material and/or personal damage. Therefore, make sure that you are
properly insured when using the model, e.g. by taking out private liability insurance. If you already have
insurance, enquire whether the operation of the model is covered before operating it.
• The unauthorized conversion and/or modification of the product is inadmissible for safety and approval reasons
(CE).
• The product is not a toy. It is not suitable for children under 14 years of age.
• The product must not become damp or wet.
• Do not leave the packaging material lying around carelessly as it can become a dangerous toy for children.
• Should any questions arise that are not answered in the operating instructions, contact our technical support (see
chapter 1 for contact information) or another expert.
Operating and handling remote-controlled model vehicles must be learned! If you have never controlled
such a model, start especially carefully to get used to how it responds to the remote commands. Proceed
with patience!
b) Operation
• Whenever you use the product, first make sure that there are no other models operated on the same frequency
within the range of the remote control. Control of the wireless models will be lost! Always use different frequencies.
• Before operation, the forward and reverse trim settings as well as the steering trim settings have to be checked '
and – if necessary – adjusted.
This is why the wheels of the vehicle must not be placed on the ground yet when the vehicle is put into operation;
hold the vehicle so that the wheels can turn freely (do not touch the driving mechanism!).
25