Jotul F 500 ECO Manuel D'installation Et D'utilisation page 15

7.3 Replacing the burn plates
Fig. 20a Replacing the rear burn plate
1. Loosen the rear burn plate by unscrewing the screws as shown
in the figure. The screws are continuous and have nuts on the
back of the stove. (see fig.20b)
Fig. 20b
Fig. 20c
2. Edge the rear burn plate out of the stove.
3. When refitting, follow the same procedure in reverse order.
(first see fig. 21 (insulation mats))
Fig. 21 Replacing the insulation mats
A
4. Behind the rear burn plate there are 5 insulation mats. They
must be replaced when replacing the rear burn plate. Lay
the new rear burn plate on a suitable surface and place the
insulation mats as shown in the figure. NB: It is important
that the insulation mats are placed according to the figure,
as there are different thickness of the mats. Insulation mat
A = 19mm thick (2 pieces), B = 25mm thick (3 pieces).
ENGLISH
B
15