Ricoh PJ X3131 Mode D'emploi page 25

Lamp replacement (Continued)
Pull out the lamp.
5
Loosen the 3 lamp locking screws, pull up the
handle, and press the tab to remove the lamp.
Mount the new lamp.
6
Align the orientation, press down the new lamp
until the bottom is reached, and lock in place
using the 3 lamp locking screws.
7
Replace the inner lamp cover.
Reattach both screws removed in step
screws until the inner lamp cover is fully immobile.
8
Replace the outer lamp cover.
Reseat the outer lamp cover by sliding it in the
direction of the arrows (as shown in the illustration),
and then tighten the screw loosened in step
Tighten the screw until the outer lamp cover is fully
immobile. (The outer lamp cover must be attached.)
9
Reset the lamp time.
See the lamp's manual for instructions on resetting
the lamp time.
Inner lamp cover
4
. Tighten the
Outer lamp cover
3
.
24
Tab