Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turning the power on and off
■
Connecting the power cord
Insert the power cord connector into
1
the AC IN socket of the projector.
2
Insert the power cord plug into a
wall or other power outlet.
The ON/STANDBY indicator flashes green and the
projector enters standby mode.
■
Turning the power on
Removing the lens cap
1
Be sure to remove the lens cap when the power is turned on. If the cap is left on the
projector, it could become deformed due to heat.
2
Press the ON/STANDBY button.
The power turns on with a beep sound (if the beep
sound is set to [On]), and the ON/STANDBY indicator
flashes orange, and then flashes green. After a
moment, the start-up screen appears.
CAUTION
•
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyesight.
•
Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
•
Do not place your hands, face, or other objects near the air exhaust, the lamp cover or the
bottom of the unit. Doing so could result in injury and/or damage the object.
Notes
•
The start-up screen will disappear after a moment. You can configure the system to
prevent the start-up screen from appearing. To do this, use the Display setting menu.
•
The first time you use the projector after purchase, after the start-up screen disappears,
the start menu is displayed.
•
You can disable the beep sound in the Default setting 1 menu.
•
When [Key lock] is [On], the operation buttons of the projector do not work.
•
When [Password] is [On], enter password then the start-up screen is displayed after the
Password entry screen disappears.
•
Do not touch the lens directly with your hand.
If fingerprints or stains are left on the projection lens surface, they may interfere with the
projector's ability to project images on the screen.
Operations
21
Power cord connector
(Supplied)
Remote
Control panel
control
Publicité
Table des Matières
