Assembly And Operation Turbowash - Storch ColorFree top Mode D'emploi

Assembling the TurboWash
Fig. 5
- Attach the TurboWash to the rear left of the rear wall of
the washing station Fig, 5, 6, 7 using the holes provided
for this purpose.
Caution:
The TurboWash may only be operated with a max. wor-
king pressure of 20 bar! Operation is only permitted
with the mains water connection or the booster pump by
STORCH. (Already installed in the ColorFree TOP Set).
Booster pump:
If a STORCH pressure booster pump is used to ope-
rate the TurboWash, make sure that the water supply is
always available when the system is switched on and that
the water tap is open! The separating system must always
be switched on to operate the pump. Further informati-
on about the pressure booster pump can be found in the
separate operating manual for the pressure booster pump.
Translation of the original operating instructions
(5) (Already installed in the ColorFree top - Set)
Fig. 6
- The 4 spacer sleeves and screws with washers are used.
Operating the TurboWash
- Paint out the roller to be cleaned first.
- Open TurboWash cover
- Insert roller and close cover
- Open ball valve completely and balance the roller to
- Close ball valve, allow roller to run down
- Remove the roller, rotate it through 180° and put the
58
achieve maximum speed
roller back into the TurboWash.
(5)