Display Language; Flocculation Results - Storch ColorFree top Mode D'emploi

Note:
Before the washing water can be treated during further
operation, a minimum water level must be available
(water level 1) Fig. 4.
The maximum water level is at the TOP notch of the
stirring rod (water level 2). When filling, note that more
water will be added for cleaning the work surface.
Figure water levels
Water level 1: Between TOP edge of guide plate on bot-
tom and end of round agitator shaft
Water level 2: End of round agitator shaft and TOP notch
on rectangular housing of agitator shaft
Tip:
The most efficient way to work is to collect tools
for washing out to ensure that the reaction tank
is always filled to the maximum water level (2).
2.
After the reaction tank has been filled, flocculation of the
wash water can begin:
Note on display language:
The languages German, French and English are available.
If you need to set a different display language, proceed as
follows:
Switch on the system at the on/off switch of the control.
- Wait for a beep
- After the beep, but before the prompt "Both filters
new?" is displayed, press both buttons once simultane-
ously, the display shows "Test mode", press both but-
tons again, the display shows the operating hours; press
again to display "Language", then select the language
- After selecting the language, switch off the system and
wait 10 seconds before switching on again
Switching on
- Switch on the system at the on/off switch of the control
(4) Fig. 1
- Then follow the display of the semi-automatic control
for the chronological water treatment sequence.
When you are asked to sprinkle in the separating agent,
sprinkle it in carefully and evenly throughout the reaction
tank. Never fill in the entire quantity at once, as there is a
risk of lumps forming.
Translation of the original operating instructions
Water level 2
Water level 1
Fig. 4
Follow the dosing instructions shown on the system dis-
play and sprinkle the splitting agent using the dosing flap.
A smoothed scoop holds approx. 100 g of splitting agent.
Tip: If you need to perform a further separation procedure
after the first separation procedure, you can collect around
100 litres of washing water until the reaction tank is full.
Leave the system switched on and press "Next separati-
on".
If further procedures have to be carried out afterwards,
we recommend additional filter cages which can be repla-
ced after removing a cage filled with sediment from the
system.
The cages filled with sediment are then placed in the
external draining basket for further draining. Gather the
filter cloths from the first cage together at the edges and
close them by twisting them shut: now you can place the
second cage in the first one, which will squeeze out the
lower filter and drain it more quickly.
Notes on the flocculation results:
If the water is still strongly discoloured even after admi-
xing for the second time, manual stirring of solidified
56