Jtesting The Safeties Of The Machine - Cassese MACH 4 UNI Mode D'emploi

USER MANUAL
7.J TESTING THE SAFETIES OF THE MACHINE
Make sure the machine will switch ON/OFF when using the red button.
This button should remain in pushed position (OFF) until you rotate it to release it.
If not, contact your local agent to replace the button assembly.
Go in parameters screen.
Select the page N.4.
Do not put your hands on the tables, make sure there is nothing on them.
Press the pedal and check that the yellow background comes on under the line X6-
PEDALE, the background should come off when the pedal is released.
If not, contact your local agent to replace the pedal assembly.
Switch ON the
machine and plug
the air in. Go in the
execution screen and
switch back off the
air.
An alarm message
should come on
indicating pressure is
not correct, if not
contact your local
agent for diagnostic.
Make sure that machine is complete and that no part was removed, all side panels must be closed and all
screws in place. In case of missing item, use exploded views to order the missing part. Missing side panel will
expose moving part which is dangerous for operators.
Set the machine in
manual
remove
from the table and
try to
pedal. The machine
shouldn't try to shoot
with no
and the
message should be
displayed. If it tries
to staple,
contact
agent for repair.
Figure 7-19
mode,
mouldings
press the
moulding
safety
then
your local
MACH 4 UNI
Figure 7-17
Figure 7-18
Figure 7-20
44