Adjustments; Adjustment Of The Sliding Table; Bproper Adjustment Of Magnetic Adjustable Rod Clamp - Cassese MACH 4 UNI Mode D'emploi

USER MANUAL

4 ADJUSTMENTS

4.A

ADJUSTMENT OF THE SLIDING TABLE

The sliding table (see
page 6) needs to be
adjusted to be able to
set the various
stapling positions.
To do this, switch on
the Pre-Clamp button.
Shift the sliding table
in order to tighten
both mouldings with
the rebate clamp
(see page 6).
Then tighten the
sliding table handle .
4.B PROPER ADJUSTMENT OF MAGNETIC ADJUSTABLE ROD CLAMP
A magnetic
adjustable rod
clamp comes with
your machine as a
standard feature.
It fits the crossbar
thanks to the
locking ring and
can be set at 1 to 7
positions.
When adjusting the vertical rod clamp, closer it is from the top of the moulding, and faster will be
the machine. The machine will not damage the moulding, even if the distance is very close. If the
distance is superior to 50mm, the wedge will not penetrate fully inside the wood.
Unscrew the sliding
table handle.
Figure 4-1
Switch back off the
Pre-Clamp button in
order to release the
mouldings
remove
moulding that was
against the
fence.
Figure 4-3
Pull the black knob
to be able to adjust
the space between
the vertical
and the top of the
moulding. You must
have 50mm (2") max
between the clamp
and the top of the
moulding.
Figure 4-5
and
the
back
clamp
MACH 4 UNI
Figure 4-2
Figure 4-4
Figure 4-6
14