Dadvanced Screen: Preparing The Execution; Selecting The Stapling Mode; Auto Mode; Selecting The Speed - Cassese MACH 4 UNI Mode D'emploi

USER MANUAL
5.D ADVANCED SCREEN: PREPARING THE EXECUTION
Once the parameters are set correctly ( chapter 5.A ADVANCED SCREEN: PROGRAMMING A PROFILE), you can then configure the
execution.
5.D.a

Selecting the stapling mode

Select the mode you would like to use for stapling. Press AUTO or MANU. The selected
mode will remain black background.
MANUAL MODE : this mode will require two actions to get the corner done. Pressing
the pedal will engage the front clamps to keep both mouldings together. You can then
check the joining before launching the stapling with the stapling button. Manual mode
will be selected by default at each power up of the machine.
AUTO MODE: this is the quickest mode, the machine will engage the front clamps and
staple immediately when the pedal will be pressed.
5.D.b

Selecting the speed

The vertical clamp speed can be adjusted depending on the hardness of the wood.
Using that button will set the speed of the vertical clamp. Press that button to select
turtle or rabbit mode.
TURTLE MODE : this mode will select a slower speed for the vertical clamp, it is useful
for very soft moulding.
RABBIT MODE: Most of the time this mode will not cause any damage to the moulding
and can be used to save time.
5.D.c

Resetting the counter

Pressing this button will help to set the counter, a keyboard will appear allowing to
reset it or to set it to a certain number.
If you set it at zero when starting production, you will see it increasing at each cycle so
you know how many cycles were done. You can also configure it so it will decrease.
Then entering the amount to be done in this field will allow you to see the remaining
cycles to be done.
This counter can be set so it counts frames or corners.
Refer to chapter I.6.B.b Page 2: counter configuration (page 32) for configuration of that
counter.
MACH 4 UNI
Figure 5-27
Figure 5-28
Figure 5-29
23