Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
5
PROGRAMMING THE MACHINE
After performing the adjustments of chapter 4 (ADJUSTMENTS). Perform the following procedure:
Put on the table only
one
chop
of
moulding against the
fence.
This will allow easy
visualization
of
stapling positions
Depending of the configuration of the machine, when you will touch the screen for the first time after power up, two screens can
come up. Both of them are showing the stapling parameters.
If
this
screen
is
displayed,
please
refer to chapter I.5.A
ADVANCED SCREEN:
PROGRAMMING
A
PROFILE (page 19).
Your
machine
is
showing
the
advanced screen.
5.A
ADVANCED SCREEN: PROGRAMMING A PROFILE
Still with the pre-
clamping button in
ON position, press
RAZ button to clear
last job
that was
already
in
the
memory
of
the
machine.
Rotate
the
clamping button in
the ON position.
Figure 5-1
If
this
screen
displayed,
refer to chapter I.5.F
SIMPLE
PROGRAMMING
PROFILE (page 25).
Your
machine
showing the simple
screen.
Figure 5-3
Touch the number of
the position you wish
to program. Number
one
is
position that will be
executed, number 9
will be the last one.
The MACH 4 UNI can
start from the back
or from the front of
the moulding.
Figure 5-5
pre-
is
please
SCREEN:
A
is
the
first
MACH 4 UNI
Figure 5-2
Figure 5-4
Figure 5-6
19
Publicité
Table des Matières
Dépannage
