Dselecting The Wedges Positions; Ethree Essential Rules; Fadjusting The Joining Angle - Cassese MACH 4 UNI Mode D'emploi

USER MANUAL
4.D SELECTING THE WEDGES POSITIONS
The MACH 4 UNI is designed to join mouldings in 1 to 9 positions. You can stack up to 9 wedges in each position. The selection
depends on the width and thickness of the moulding to join.
4.E THREE ESSENTIAL RULES
1- A MINIMUM 2 mm clearance (less than 1/8") above the wedges shall be
respected.
2- Same size wedges can be stacked up in order to avoid having to change the
wedge size when joining mouldings with different thickness.
3- The wedge positions should be lined up to the highest points of the moulding.
When selecting the position of the top clamp, always pay attention to its contact surface with the
moulding. Select positions that will provide steady seating.
4.F ADJUSTING THE JOINING ANGLE
If the corner is
opened towards
outside
If the corner is
opened towards
inside.
If you get this result : it means your cutting angle is less than 45°.
Your cutting machine needs to be set to the right 45° angle (check your cutting
machine's user manual to make this adjustment).
Tighten
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the angle
clamping the corner
against
fences again.
Figure 4-15
Loosen
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the angle
clamping the corner
against
fences again.
Figure 4-17
the
to
by
the back
the
to
by
the back
MACH 4 UNI
Figure 4-14
Figure 4-16
Figure 4-18
Figure 4-19
16