Cremoving The Distributor Head; Dopening The Side Panels - Cassese MACH 4 UNI Mode D'emploi

USER MANUAL
7.C REMOVING THE DISTRIBUTOR HEAD
Allen key N. 2,5
To load the machine,
rotate the loading
button in the load
position.
The wedge pusher
will move back.
Using the 2.5mm
Allen key, unlock the
holding screw of the
head and remove the
head.
7.D OPENING THE SIDE PANELS
Prior to perform any maintenance, switch off and lock Electricity/air supplies, follow chapter I.7.A
Allen key N.3&2.5mm
Using the 3mm Allen
key, remove the 4
screws of the side
panel and remove
the panel of the
machine.
Unlock the
table and open it to
its wider capacity.
Figure 7-3
Using the Allen key
of 2.5mm, extract the
eventual
wedges of the head.
Figure 7-5
INSTRUCTIONS (page40) for your safety
Figure 7-7
sliding
remaining
MACH 4 UNI
Figure 7-4
Figure 7-6
SAFETY
41