Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
3.D
SELECTING THE WEDGES POSITIONS
The CS200 CART is designed to join mouldings in 2 positions that will be selected using side handles, but you can stop in any
other position between the 2 extreme positons. You can stack several wedges in each position.
3.E
THREE ESSENTIAL RULES
1- A MINIMUM 2 mm clearance (less than 1/8") above the wedges shall be
respected.
2- Same size wedges can be stacked up in order to avoid having to change the
wedge size when joining mouldings with different thickness.
3- The wedge positions should be lined up to the highest points of the moulding.
When selecting the position of the top clamp, always pay attention to its contact surface with the
moulding. Select positions that will provide steady seating.
3.F
ADJUSTING THE JOINING ANGLE
If
the
corner
is
opened
towards
outside
If
the
corner
is
opened
towards
inside.
If you get this result : it means your cutting angle is less than 45°.
Your cutting machine needs to be set to the right 45° angle (check your cutting
machine's user manual to make this adjustment).
Tighten
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the
angle
clamping the corner
against
fences again.
Figure 3-15
Loosen
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the
angle
clamping the corner
against
fences again.
Figure 3-17
the
to
by
the
back
the
to
by
the
back
CS200 CART
Figure 3-14
Figure 3-16
Figure 3-18
Figure 3-19
14
Publicité
Table des Matières
