Water Inlet - Schulthess WA14 Export Notice D'installation

Water inlet

For the water connection, a normal
cold­water supply with at least 0,1 MPa
(1 bar) water pressure is required. When
the water tap is turned on, more than 8
litres of water per minute must flow out.
If the water pressure is over 1 MPa
►
(10 bar), a pressure valve should be
fitted.
Important
Do not connect to the mixing battery of
a pressureless hot­water apparatus.
Hoop up the machine with like new inlet
hoses. Do not reuse old hose kits.
Do not kink or protract the hoses.
►
Connect the inlet hose to the water tap.
►
Do not remove the screens in the hose
►
connections, except for cleaning.
50 EN
Carefully turn on the water tap to make
►
sure that the connections are not
leaking.
Important
The connecting points are under full
water pressure.
In order to avoid water damage, the
water tap and the intermediate valve
must be closed after washing.
Soft water/ rainwater connection
Notice
If you wish to use rainwater, this must
be filtered or hygienically clean to avoid
contamination.
A rainwater utilisation system is required
►
to operate your washing machine with
rainwater.
Machines with soft water/ rainwater
option provide two water con nections
on the rear panel for the soft and hard
water connection (cold) respectively.
The supply valve for soft water/ rain­
water is marked with a green line at the
mouth, the neutral valve is determined
for the hard water.
Connect the soft / rain and hard water
►
hose to the respective water tap.
Hot water connection
Machines with hot water option provide
two water con nections on the rear panel
for the hot and cold water connection.