Schulthess WA14 Export Notice D'installation page 47

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation area
In order to ensure the stability of the
appliance during spin drying, the instal­
lation area must be firm and level.
Soft floor coverings, e.g. fitted carpets
or coverings with a foamed material
backing are not suitable as an installa­
tion area.
Installation on timber joist
floors
Place the appliance on an at least
40 mm thick, water­resistant timber
board which should be screwed firmly to
the floor.
Installation should be made as far as
possible in the corner of the room.
Fasten the appliance by its feet using
the fixing set (this applies particularly in
the case of a washer­dryer tower).
Installation on a plinth
Important
During spinning, the washing machine
may wander and tip over or fall from the
plinth.
The base of the device must be fixed
securely to it with a fixing set in order
to prevent it from sliding off during its
spin cycle (this applies particularly in the
case of a washer­dryer tower).
Installation on a slippery
surface
When the machine is installed on a
slippery surface (e.g. ceramic tile,
polished natural stone, fine concrete),
the feet of the machine must be secured
with an attachment set (attachment
set for glueing) to prevent the machine
from moving during spinning.
Fixing sets
You can purchase the following fixing
sets at your specialist retailer or
through our customer services team:
Steel fixing set – to be drilled
Order No: 520 510
Plastic fixing set – to be glued
Order No: 51215
EN 47

Publicité

Table des Matières
loading

Table des Matières