Working With The Meat Grinder - MIA MG 2507 Mode D'emploi

C) Assembling the Kebbe filling attachment (13)
If the meat grinder (3) is assembled as described in A):
Unscrew the locking screw (4). Remove the mincing disc (10.
1.
Carefully remove the Star cutter (9).
2.
Now insert the Kebbe disc (11) onto the spiral drive (8). Insert the two keys at the
3.
Kebbe disc (11) into the slot joints at the winding of the meat grinder (3).
Now attach the Kebbe ring (13) onto the Kebbe disc (11).
4.
If all is assembled correctly fix the locking screw (4) hand tight. Ensure that the Kebbe disc
5.
with the sausage filling attachment cannot slip off the slot joints any more while fixing the
locking screw (4). Hold it with the other hand while fixing the locking screw (4) to avoid
slipping off.
To disassemble
unscrew the locking screw (4) then remove the Kebbe ring (13) and the
Kebbe disc (11).
Caution: Do not use the appliance longer than 3 minutes. After 3 minutes of permanent
operation let the motor cool down for about 30 minutes minimum to avoid overheating.
(see „Technical data and short term operation").

Working with the meat grinder

To avoid accident and risk of injury

Never put your fingers into the filling opening of the appliance. Never insert any objects
into the filling opening – except the pusher and the food you want to mince. Otherwise
there can be extremely risk of injury!

Always unplug before assembling or disassembling any parts.

Never leave the appliance unattended when it is ready for use. For safety reason unplug
after each use and in operation breaks to avoid starting by mistake.

Always use original accessories only with the appliance.

Never leave persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge unattended while using the appliance,
because they are not always aware about the dangers which can occur while handling
with electric appliances.
Details

To avoid overheating never exceed the short term operation time. After each use let the
appliance cool down enough (see „Technical data and short term operation").

When processing bigger amounts of food always take care to keep enough breaks during
work flow.
If the desired attachments are assembled:

Position the appliance on an absolutely dry and stable working place so that it never can
slip or fall off the desk or can get near open water (e. g. by vibration or stumbling over the
cord). There might be vibrations while in operation.

WARNING: Never catch at a plugged appliance or an appliance in operation if it is
falling down or into water or any case of emergency! In case of emergency
immediately unplug! Otherwise there is extremely risk of injury and danger of life!
20