Assembling And Disassembling; Assembling The Meat Grinder - MIA MG 2507 Mode D'emploi


Some of the parts are protected against corrosion by a thin oil film. Clean all parts before
first use as described in "Cleaning, maintenance and storing". When using for the first time
little smell can occur. It is harmless and disappears after a while.

Assembling and disassembling

Caution! Make sure before you assemble any parts that the appliance is not connected
to the power supply and the switch is switched OFF (switch position '0').
Caution! The Star cutter and the mincing discs are very sharp! Take extremely care while
assembling, disassembling and cleaning.
A) Assembling the Meat Grinder
Hold the meat grinder (3) with the filling opening upward (see figure). Keep this position
1.
during assembling.
Insert the spiral drive (8) with your other hand with the side where the plastic disc is fixed
2.
firmly into the drive shaft of the meat grinder (3).
Attach the star cutter (9) onto the end of the spiral drive (8) the plan surface facing to the
3.
inner side to the spiral drive (8) means with the cutting edges to the outer side Caution:
the appliance will get damaged, if the star cutter (9) is assembled with the plan
surface to the outer side! See figures below:
Right:
Right:
18