MIA MG 2507 Mode D'emploi page 19

Wrong:
Insert the desired mincing disc (10). Take care to assemble correctly, see the slot joints at
4.
the winding of the meat grinder (3). Insert the outer keys of the mincing disc (10) fittingly
into the slot joints.
Fix the Locking screw (4) by turning it in clockwise direction until it is engaged. Ensure by
5.
slightly shaking that the locking screw (9) is fixed firmly and the star cutter is not loose and
cannot shake any more.
Insert the assembled meat grinding unit (3) into the opening of the motor unit (5). Press it
6.
slightly and turn it a little back and forth until it is entirely engaged. Insert the locking screw
(6) for the meat grinder (3) into the winding (see arrow). Then turn the lateral locking screw
(6) for the meat grinder (3) in clockwise direction till it is fixed firmly. Take care not to twist
to avoid damage of the winding.
Check if all it is fixed properly and in perfect order.
7.
Now insert the filling tray (2) onto the filling shaft of the meat grinder (3). At least insert the
8.
pusher (1).
To disassemble
remove the pusher (1) and the filling tray (2).
Then turn the lateral locking screw (6) of the meat grinder (3) in counter clockwise direction
1.
to open. Press the meat grinder slightly (3) against the unit and turn it to remove in counter
clockwise direction. Then you can pull the assembled meat grinder off and disassemble in
order to clean it. Turn the locking screw (4) in counter clockwise direction to open.
Remove the mincing disc (10).
2.
Carefully remove the star cutter (9) Caution with the star cutter (9) cause it is extremely
3.
sharp!
Carefully remove the spiral drive (8) then remove food residues (if existent) from the meat
4.
grinder (3).
Note: After each use clean the removable parts as described in „Cleaning, maintenance
and storing" as they are in contact with food and to avoid dry sticking.
B) Assembling the sausage filling attachment (12)
If the meat grinder (3) is assembled as described in A):
Unscrew the locking screw (4). Remove the mincing disc (10.
1.
Carefully remove the Star cutter (9).
2.
Now insert the Kebbe disc (11) onto the spiral drive (8). Insert the two keys at the
3.
Kebbe disc (11) into the slot joints at the winding of the meat grinder (3).
Attach the sausage filling attachment (12) onto the Kebbe disc (11).
4.
Fix the locking screw (4) hand tight. Ensure that the Kebbe disc with the sausage filling
5.
attachment cannot slip off the slot joints any more while fixing the locking screw (4).
Hold it with the other hand while fixing the locking screw (4) to avoid slipping off.
To disassemble
unscrew the locking screw (4) then remove sausage filling attachment (12)
and Kebbe disc (11).
19