Cleaning And Maintenance - EUROM Force 1430S Manuel D'utilisation

13
Extra paper filter
An extra paper filter
(dust bag) is supplied
with the device. You
are advised to replace
the HEPA filter with this
filter if you intend to
clean very fine
particles, e.g. in the
event of drilling or
sanding work. This will prevent you from having to clean the HEPA filter during
this type of work.
Install the paper dust bag as follows:
 Remove the HEPA filter (see: Cleaning the filter)
 Remove the 'knee' on the air inlet within the drum
 Slide the opening in the paper dust bag over the air intake opening
 Secure the cover (without HEPA filter, secure with
clamps)
CLEANING UP
Switch the device off and remove the plug from the socket.
Wind the electrical cable around the cable hanger; the
upper section provides a groove into which you can wedge
the plug. Place the accessories at the appropriate locations
behind the device, see image.

CLEANING AND MAINTENANCE

Before cleaning or maintenance: always switch off the equipment and unplug it.
Filter cleaning system
When you feel that the suction is
getting weaker, please remove the
tube and jam the hose by hand (while
the equipment is working). Then
press the filter cleaning button 10-15
times: this will clean the filter and
recover the suction force.
Emptying barrel
Open both the locking blocks (4) en take the up
housing from the vacuum cleaner. Remove the
dust out of the barrel and clean the barrel if