EUROM Force 1430S Manuel D'utilisation page 14

necessary. At the end, place back the up housing and close the locking blocks.
Cleaning the filter
Clean the filter regularly. Open both clips and remove the
lid of the vacuum cleaner. Turn the lid from the filter, slide
the HEPA filter off the frame and carefully wash with
lukewarm water. Do not use any aggressive or abrasive
cleaning agents!
Let the filter dry thoroughly before replacing. Never use
the device without a filter!
Maintenance:
 Keep the body of the device, the filter and accessories clean and regularly check to
ensure no excess air is being sucked in.
 Check the cable and plug regularly for damage. Do not use the device if it has a
damaged cable and/or plug but take it to an authorised engineer to be replaced!
 Regularly check to ensure no objects are stuck in the suction mouth, hose or pipe.
Remove them if necessary.
 Use the device carefully; ensure it does not fall, bump into other objects or become
otherwise damaged.
 Store the device in a dry environment.
 Never use the device for too long in one go; give it regular opportunities to cool down.
This will extend its life expectancy.
 If the device falters, vibrates, makes peculiar noises or emits a burning smell, stop
using it immediately and ask your supplier or service provider to check/repair it.
CE - STATEMENT
Euromac bv., Genemuiden-NL hereby declares that the EUROM FORCE vacuum cleaner
type 1430S wet/dry complies with the LVD guideline 2014/35/EU and the EMC guideline
2014/30/EU and meets the following standards:
EN 60335-2-2 :2010+A11:2012+A1 :2013
EN 60335-1 :2012+A11 :2014
EN 62233 :2008
Genemuiden, 20-03-2018
W.J. Bakker, alg. dir.
14
EN 55014-1 :2006+A1 :2009+A2 :2011
EN 55014-2 :1997+A1 :2001+A2 :2008
EN 61000-3-2 :2014
EN 61000-3-3 :2013