EUROM Force 1430S Manuel D'utilisation page 12

Masquer les pouces Voir aussi pour Force 1430S:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 You can adjust the telescope tube by pushing the
sliding block 2A down and and tracking/pushing the
lowest tube to the length you wish.
 Insert the plug into the earthed socket.
 Press the switch on/off to I to turn on.
 You can adjust the airflow by pushing the sliding block 1B up and down.
 If necessary, due to the surface and task, the hair or rubber strips can be removed
from the suction mouth. In order to do so, slide the discs on the suction mouth
outwards, take the strip holder from the suction mouth, slide the excess strip out and
replace the holder.
 For the vacuuming of liquid the motor (which is situated in
the cap) is provided with a floater that is hanging under the
motor, in the barrel. For the vacuuming of dry dirt and dust
the motor is provided with a filter that the floater
surrounds and in that way prevents that dust enters the
mechanic system. Do you want to vacuum liquid, remove
than the filter by opening the locking blocks, to lift and turn
the cap, to turn the lid from the filter (see image), and to
slide the filter from the floaters frame. Now you can
remove the filter. Bring the cap back in its position and
close the blocks.
 Be carefull!
 Never vacuum dust without the Hepa filter around the floater!
 Never vacuum liquid without the water filter around the floater!
Tank drain
The Force 1430S has the possibility to drain the sucked-up water by the tank drain at the
barrel. For this purpose, place the device at a sink or something like that and loosen the
tank drain: the water is now running away. Finally tighten the cap firmly again.
Socket
In order to use the socket, you must lift the lid and insert the plug into the socket. Then
use the ON/OFF switch to select the appropriate setting:
I
= device works, power from socket
O
= device off, power to socket (max. 2000W)
II
= Power to socket, connected device will work. After 5-8 seconds
clean will start. If the connected device is switched off, the vacuum cleaner will also stop
after 5-8 seconds.
12
the vacuum

Publicité

Table des Matières
loading

Table des Matières