Cleaning And Maintenance - EUROM Force 1420S wet/dry Manuel D'utilisation

O = device off, power to socket (max. 1800W)
II = Power to socket, connected device will work. After 5-8 seconds the
vacuum clean will start. If the connected device is switched off, the vacuum cleaner
will also stop after 5-8 seconds.
Extra paper filter
An extra paper
filter (dust bag) is
supplied with the
device. You are
advised to replace
the HEPA filter
with this filter if
you intend to
clean very fine
particles, e.g. in
the event of drilling or sanding work. This will prevent you from having to clean the
HEPA filter during
this type of work.
Install the paper dust bag as follows:
 Remove the HEPA filter (see: Cleaning the filter)
 Remove the 'knee' on the air inlet within the drum
 Slide the opening in the paper dust bag over the air intake opening
 Secure the cover (without HEPA filter, secure with clamps)
To clean up
Switch the device off and remove the plug from the
socket. Wind the electrical cable around the cable
hanger; the upper section provides a groove into
which you can wedge the plug. Place the accessories
at the appropriate locations behind the device, see
image.

Cleaning and maintenance

Before cleaning or maintenance: always switch off the equipment and unplug it.
15