Electrical Hazards - Mi-T-M GEN-6000-0MKD Mode D'emploi

ELECTRICAL HAZARDS

This product must be grounded. It has permanent conductor between
the generator (stator winding) and the frame. If it should malfunction or
breakdown, grounding provides a path of least resistance for electric
current to reduce the risk of electric shock.
DANGER - IMPROPER CONNECTION OF THE EQUIPMENT-
GROUNDING CONDUCTOR CAN RESULT IN A RISK
OF ELECTROCUTION.
ELECTRICIAN OR SERVICE PERSON IF YOU ARE INDOUBT
AS TO WHETHER THE UNIT IS PROPERLY GROUNDED.
This generator is equipped with a grounding terminal for your protec-
tion. Always complete the ground path from the generator to an external
ground source as instructed in the section labeled "Grounding Instruc-
tions" in the Preparation section of this manual.
The generator is a potential source of electrical shock if not kept dry.
Keep the generator dry and do not use in rain or wet conditions. To pro-
tect from moisture, operate it on a dry surface under an open, canopy-
like structure. Dry your hands if wet before touching the generator.
Risk of electric shock if you operate this generator with a faulty GFCI
(Ground Fault Circuit Interrupter). Test GFCI before each use, see Op-
erations Instructions for further information. If GFCI fails test, DO NOT
use your generator. Contact your Mi-T-M Customer Service Represen-
tative.
Plug appliances directly into the generator. Or, use a heavy duty, out-
door-rated extension cord that is rated (in watts or amps) at least equal
to the sum of the connected appliance loads. Check that the entire cord
is free of cuts or tears and that the plug has all three prongs, especially
a grounding pin.
NEVER try to power the house wiring by plugging the generator into
a wall outlet, a practice known as "back feeding". This is an extremely
dangerous practice that presents an electrocution risk to utility workers
and neighbors served by the same utility transformer. It also bypasses
some of the built-in household circuit protection devices.
If you must connect the generator to the house wiring to power appli-
ances, have a qualified electrician install the appropriate equipment in
accordance with local electrical codes. Or, check with your utility com-
pany to see if it can install an appropriate power transfer switch.
For power outages, permanently installed stationary generators are
better suited for providing backup power to the home. Even a properly
connected portable generator can become overloaded. This may result
in overheating or stressing the generator components, possibly leading
to a generator failure.
Operator's Manual
CHECK WITH A QUALIFIED
7