Troubleshooting The Tractor - Briggs & Stratton Intek Série Manuel D'utilisation

Troubleshooting

Troubleshooting the Tractor

PROBLEM
Engine will not turnover
or start.
Engine starts hard or
runs poorly.
Engine knocks.
Excessive oil
consumption.
Engine exhaust is
black.
Engine runs, but tractor
will not drive.
Tractor steers hard or
handles poorly.
NOTE: For all other problems, contact an Authorized Service Dealer.
LOOK FOR
Brake pedal not
depressed.
PTO (electric clutch) switch
is in ON position.
Cruise control engaged.
Out of fuel.
Engine flooded.
Battery terminals require
cleaning.
Battery discharged or
dead.
Wiring loose or broken.
Fuel mixture too rich.
Low oil level.
Using wrong grade oil.
Using wrong grade oil.
Too much oil in
crankcase.
Dirty air filter.
Choke closed.
Ground speed control
pedals not depressed.
Transmission release
lever in PUSH position.
Parking brake is engaged. Disengage parking brake.
Improper tire inflation.
Fully depress brake pedal.
Place in OFF position.
Move knob to NEUTRAL/OFF position.
If engine is hot, allow it to cool, then refill the fuel tank.
Disengage the choke.
See Cleaning the Battery and Cables section.
Recharge or replace battery.
Visually check wiring. If wires are frayed or broken, see authorized
dealer.
Clean air filter.
Check/add oil as required.
See Oil Recommendations Chart.
See Oil Recommendations Chart.
Drain excess oil.
See Servicing the Air Filter section.
Open choke.
Depress pedals.
Move into DRIVE position.
See Check Tire Pressure section.
REMEDY
23
en