Carbon Filters; Removing Filter Panel/Filter; Changing The Light Bulbs; Cleaning - Pelgrim SLK 700 Notice D'utilisation

Carbon filters

The carbon filter must be used if the cooker
hood is not connected to a duct (see
extraction systems on page 12).
Note:
The carbon filter must be replaced at least
twice a year, depending on how much the
cooker hood is used.
Carbon filters cannot be cleaned to use
again.
Saturated carbon is harmful to the
environment, replace the filter regularly.
Assembling the carbon filter
C
P
U
Fig. 2. SLK 750/950
Press the feet (P) of the carbon filter (C) firmly
in the recesses in the filter panel (U).
Fig. 3. ISW 700/SLK 700/SLK 810
Centre the carbon filter with the sunken round
surface on top of the motor frame and turn it
to the right.

Removing filter panel/filter

Switch off the main switch.
C
B
D
Fig. 4. MSL 140 SLK 700/750/950
C
B
D
Fig. 5. SLK810
Pull out the visor (C). Press the handle (D)
slightly.
F F
Fig. 6. ISW 700
Slide handles (F) in.
Push the brackets sideways and remove from
the filter panel. Clean the filter in soapy water.
Lay the coarse mesh of the filter face down on
the filter panel.

Changing the light bulbs

SLK 700 / 750 / 950
ISW 700
MSL 140
First switch the electricity off! If it is
necessary to change the starter or the light,
remove the plastic cover (B, see fig. 4).
SLK 810
1
2
Fig. 7. SLK810
Remove the cover (1) by turning it
counterclockwise. Pull the bulb (2) in the
direction of the arrow and out of the holder,
then fit the new bulb. Take care not to touch
the bulb with your hands when you replace it,
since direct contact with the skin can result in
the bulb burning out.

Cleaning

Cooker hood
Clean the cooker hood with soapy water, then
wipe with clean water to rinse. Do not use
aggressive cleaning agents such as soda. The
cooker hood paintwork will stay looking nice if
you wax it occasionally.
Filters
Wash aluminium filters, every week in
soapy water. The cleaning agents will
make the aluminium filter turn dull, this is
normal.
Some models are fitted with fibre filters.
These can only be washed once or twice
and must therefore be replaced regularly.
The carbon filters cannot be cleaned to use
again.