Preparing For Use; What's In The Box; Checking The Front Hand Guard Position - Oregon CS1500-091 Manuel D'instructions Original

PREPARING FOR USE

PREPARING FOR USE
DANGER: TO AVOID SERIOUS
PERSONAL INJURY, DO NOT OPERATE
THE CHAIN SAW WITHOUT THE GUIDE
BAR, SAW CHAIN AND SIDE COVER
PROPERLY ASSEMBLED.
WARNING: DO NOT ATTEMPT TO
OPERATE THE CHAIN SAW IF ANY PART IS
DAMAGED OR MISSING.
WARNING: AN ELECTRIC POWER
TOOL THAT IS PLUGGED IN CAN START
ACCIDENTALLY. UNPLUG THE CHAIN
SAW BEFORE PREPARING FOR USE OR
PERFORMING MAINTENANCE.

WHAT'S IN THE BOX?

These items ship with the chain saw:
• Chain saw powerhead with saw chain and
guide bar attached
• Guide bar cover
• Bar and chain oil
After removing the chain saw from the box,
inspect it carefully to ensure no damage
has occurred during shipping, and that no
parts are missing If any parts are damaged
or missing, do not use the chain saw
Contact OREGON® at 800 223 5168 to obtain
replacement parts
12
CHECKING THE FRONT
HAND GUARD POSITION
After unpacking the chain saw, check the
position of the front hand guard The chain
saw will not run with the chain brake
engaged Pull the front hand guard back
towards the front handle before operation
(Fig 5)
FIG. 5
FRONT HAND GUARD
IN OPERATING POSITION
OREGON® CHAIN SAW
MODEL CS1500-091
FRONT HAND GUARD
IN BRAKE POSITION
F/N 570773 - AC 0614