Direct And Alternating Voltage Measurement - VOLTCRAFT CT-3 Notice D'emploi

b) Direct and alternating voltage measurement
Do not exceed the maximum permitted input values; this also
applies when measuring superimposed direct voltages (e.g. ripple
voltages).
Proceed as follows to measure voltages:
- Turn the multimeter on using the rotary
and select measuring range „VDC" for
direct voltage or „VAC" for alternating
voltage. The display shows „DC" or
„AC".
- Insert the measuring lines into the
measuring sockets.
- Now connect the two test prods to the
object to be measured (battery, circuit
etc.).
- The measuring value is shown on the
display (2).
The voltage range "V DC/AC" shows an input resistance of >7.5 MOhm. If
a minus "-" appears for direct voltage in front of the measured value, the
measured voltage is negative (or the measuring leads have been mixed
up). If OL appears, then the voltage exceeds the measuring range.
38
switch (1)