Direct And Alternating Voltage Measurement - VOLTCRAFT ST-100 Notice D'emploi

b) Direct and Alternating Voltage Measurement
Do not exceed the maximum permitted input values, not even when bearing
overlaid direct voltages (e.g. ripple voltages).
Proceed as follows to measure voltages:
- Switch on the DMM at the
dial switch (1) and select the
measuring range „VDC" for
direct voltage or „VAC" for alter-
nate voltage. The display shows
the „DC or „AC".
- Insert the measuring lines into
the measuring jacks.
- Connect the two measuring
prods to the object to be meas-
ured (battery, circuit, etc.).
- The measuring value is shown
on the display (2).
The voltage range „V DC/AC" has an input resistance of >7.5 MOhm. Once a
minus „-" appears in front of the measured value for direct voltage, the measured
voltage is negative (or the measuring lines are swapped). If OL appears, the measur-
ing range was exceeded
35