What Should I Do If; Troubleshooting - Seca 465 Mode D'emploi Et Garantie

7. WHAT SHOULD I DO IF ...?

7.1 Troubleshooting

Fault
seca 466:
Paper LED on
seca 465:
Error LED on
seca 466:
Paper LED on
Error LED on
Error LED flashes
during printing
Error LED on when no
printing in progress
Printing stops
Error LED flashing
Power LED flashing
seca 466:
Error LED flashing
seca 466:
Power LED off
Error LED flashing
Paper LED flashing
seca 466:
Error LED flashing
70 •
Paper running out
- Insert new paper
No paper
- Insert new paper
Paper compartment cover not properly closed
- Close paper compartment cover until you hear it
engage.
Paper compartment cover not properly closed
- Close paper compartment cover until you hear it
engage.
Print head overheated, e.g. text too dense or dark areas
being printed
- Wait for print head to cool down. Printer automatically
resumes printing. Error LED goes out.
Memory test fault
- Contact seca Service
Paper cutter blocked
- Switch off device
- Remove paper residues
- Switch on device
- Press Feed key
- If problem persists: see "Reset paper cutter
(seca 466)" on page 72
If automatic paper cutter is deactivated: printer waiting for
printout to be cut off:
- use manual cutter to cut off printout.
Paper type sensors not set correctly
- Set paper type sensors: see "Adjust sensors for
labels and Black Mark paper" on page 55
Cause/Remedy