Set Date And Time - Seca 465 Mode D'emploi Et Garantie

Connecting
Wireless
module
On/Off switch
Application
$ProjectRevision: 1.19 $
Veryfing file checksums
Finished
Reading Master-Image-file
Downloading images to printer
Finished
Reading-Master-File
Finished
Reading BMI-File
Finished
Reading Master-Table-File
Finished
Printer ready

Set date and time

58 •
The wireless module for the printer is not switched on
using the On/Off switch for the printer. The wireless
module is permanently supplied with power by the
power supply unit for the printer.
For the printer to be detected correctly in the wireless
network, both the printer itself and the wireless module
must be de-energized briefly. Proceed as follows.
1. Ensure that the On/Off switch of the printer is set to
socket
"Off".
2. Disconnect the device plug from the printer's
power supply connection socket.
The printer and the wireless module are
de-energized.
3. Start setting up the wireless network as described
in the instruction manual for your seca 360°
wireless measuring device.
4. When the instruction manual for your seca 360°
wireless measuring device requests you to switch
on all the components of the wireless group,
proceed as follows.
– If a wireless group already exists, switch on
– Plug the device plug into the printer's power
– Switch on the printer at the On/Off switch.
The printer performs a self-test and prints out a test
page with the current settings.
5. Continue setting up the wireless network as
described in the instruction manual for your
seca 360° wireless measuring device.
Date and time cannot be set directly on the printer.
Date and time are set on a seca 360° wireless
measuring device and transmitted wirelessly to the
printer. The prerequisite is that the printer and the
seca 360° wireless measuring device are logged on
to the same wireless group.
its components.
supply connection socket.