Seca 465 Mode D'emploi Et Garantie page 56

Label length
Gap between labels
Label Length : XXXmm
Gap Length : XXmm
Example for label measurement
Interval between black marks
Height of black mark
Black mark Interval
Black mark Length
Example for Black Mark paper
measurement
56 •
9. Turn the relevant sensor adjusting wheel for the
paper in use clockwise until the Paper type
sensors LED goes out.
10. Slowly turn the sensor adjusting wheel
anticlockwise until the Paper type sensors LED
comes on.
The sensor is set correctly.
11. Close the cover for the paper type sensors.
12. For reference purposes, you can now measure the
: XXXmm
labels or the Black Mark paper. To do so, press the
: XXmm
Feed key.
The measurement results are printed out.
NOTE
If you turn the sensor adjusting wheel too far
clockwise, the Paper type sensors LED starts
flashing. In this case, slowly turn the sensor
adjusting wheel back until the Paper type
sensors LED comes back on.