Use Configuration Program; Install Configuration Program - Seca 465 Mode D'emploi Et Garantie

5.2 Use configuration program

Install configuration
program
For details on setting date and time, see the instruction
manual for the seca 360° wireless measuring device
in question.
The seca Print Designer Software allows
measurement results to be printed out adapted to suit
local regulations and your own requirements.
NOTE
The printer is pre-configured to be operational.
You need only use this software if you do not
wish to use the factory settings (see "Restore
factory settings (reset)" on page 67).
You have the following setting options:
• select references for evaluating measurement results
• use your own logo
• select layout files to control the content and
appearance of printouts
seca Print Designer Software is on the SD card of
the printer. In order to be able to use the software, you
must connect the SD card to your PC as a removable
disk and install the software.
Should your PC not have a suitable card reader, use
the USB memory card reader supplied.
NOTE
seca Print Designer Software requires
®
Microsoft .NET Framework 3.5. This software
is included on the SD card supplied. Framework
is already installed on many PCs, in which case
you do not need to install it again. If you are
unsure whether you need to install Framework,
or whether an older version of Framework is
installed on your computer, contact your
administrator.
1. Plug the USB memory card reader supplied into a
free USB port on your PC.
2. Take the SD card out of the printer's card reader.
3. Plug the SD card into the USB memory card
reader.
The USB memory card is displayed as a removable
disk.
English
Operation • 59