Clean The Print Head - Seca 465 Mode D'emploi Et Garantie

6.2 Clean the print head

ATTENTION!
Damage to device from unsuitable cleaning
agents
− Do not use volatile organic solvents such as
alcohol, turpentine or benzene.
− Do not use cleaning cloths impregnated with
chemicals.
3. Clean the printer housing
– Clean the housing with a clean, dry cloth.
– Remove heavy soiling with a slightly moist
cloth.
– Remove paper dust using a soft brush.
The print head should be cleaned at the following
intervals depending on the paper used:
• thermal paper: once a month
• labels: every 10,000 labels, as adhesive can become
deposited on the print head.
CAUTION!
Burns and cuts
− Do not touch the print head. This is very hot
immediately after printing.
− Do not touch the paper cutter.
− Do not hold the paper by the edges. These
too can cause cuts.
1. Switch off the printer.
2. Open the paper compartment cover.
3. Wait a few minutes for the print head to cool down.
4. Clean the print head using a cotton cloth and a little
ethanol.
English
Cleaning • 69