Insert Paper Roll - Seca 465 Mode D'emploi Et Garantie

POWER ERROR
FEED
PAPER

Insert paper roll

54 •
4. Keep the Feed key depressed and switch on the
device.
The Power LED flashes.
5. Release the Feed key.
6. Close the paper compartment cover.
The Paper LED comes on.
The type of paper currently set is displayed by the
Power LED and the Error LED.
Type of paper
Labels
Thermal paper
Black Mark paper
7. Press the Feed key until the Power and Error
LEDs display the type of paper in use.
8. Open and close the paper compartment cover.
The set paper type is now stored.
NOTE
As no paper has yet been inserted, the Power,
Error and Paper LEDs ("Paper" error message)
come on. As soon as you have inserted paper,
only the Power LED is on. The device is then
operational.
Proceed as outlined below to insert paper in the printer.
1. Ensure that the device is switched off.
CAUTION!
Burns and cuts
− Do not touch the print head. This is very hot
immediately after printing.
− Do not touch the paper cutter.
− Do not hold the paper by the edges. These
too can cause cuts.
2. Open the paper compartment cover.
3. Insert the paper roll.
NOTE
Ensure that the paper roll is correctly aligned.
See adjacent illustration.
4. Close the paper compartment cover until you hear
it engage.
The device is operational.
Power LED Error LED
On Off
Off On
On On