External Cleaning; Frost Precautions; What To Do If - Zanussi ZDI121 Mode D'emploi

5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
Important! Do not remove the spray arms.

What to do if...

The appliance does not start or stops during operation.
Fault code and malfunction
• continuous flash of the start/cancel in-
dicator light
• 1 flash of the end indicator light
The dishwasher does not fill with water
• continuous flash of the start/cancel in-
dicator light
• 2 flashes of the end indicator light
The dishwasher will not drain
• continuous flash of the start/cancel in-
dicator light
• 3 flashes of the end indicator light
The anti-flood device operates
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• Close the water tap and contact your local Service Force Centre.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral detergents.
Do not use abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
Possible cause and solution
27