External Cleaning; Frost Precautions; What To Do If - Zanussi ZDT101 Notice D'utilisation

1
3
To remove filters B and C,
turn the handle approxi-
mately 1/4 anticlockwise.
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.

What to do if...

The appliance does not start or stops during operation.
2
Fully clean the filters A, B
and C below running wa-
ter.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral detergents.
Do not use abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
27