Care And Cleaning; Cleaning The Filters; External Cleaning; Frost Precautions - Zanussi ZDT110 Notice D'utilisation

End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The audible signals for the end of the programme op-
erate.
1. Open the door.
– The end indicator light comes on.
– The programme indicator light stays on.
2. Press the on/off button.

Care and cleaning

Warning! Switch the appliance off before you clean
the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1
3
To remove filters B and C,
turn the handle approxi-
mately 1/4 anticlockwise.
26
2
Fully clean the filters A, B
and C below running wa-
ter.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
3. For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the appli-
ance. Stainless steel becomes cool more quickly than
the dishes.
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral detergents.
Do not use abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.