Clamping Of Workpieces; Feed; Cutting Speed (Guide Values) - HOLZMANN MASCHINEN BF500D Mode D'emploi

With collet holder:
Finger or end mills are clamped with collet holders. Use only the appropriate
collets and clean them before inserting (concentricity) and clamp them well
with the tightening nut. If the milling cutter is clamped on the machine, it
must be held to prevent it from falling down. The cutting edges are sensitive
to impacts. All tools with cylindrical shank and corresponding diameter can be
clamped in the collet holder.
Arbor cutters:
Shell end mills, side milling cutters and milling heads are clamped on arbors.
For driving the milling cutters, arbors are equipped with a longitudinal wedge or
a driver. Never clamp end mills without a longitudinal wedge or driver. Side
milling cutters can be clamped with right- or left-hand cutting (pay attention to
the direction of rotation). Here too, all components must be clean and must not
be damaged.
19.7.6

Clamping of workpieces

The workpieces can be clamped with machine vice, clamping screws, clamps, clamping bases, low
and flat clamps, eccentric clamps, dividing head, rotary tables, jaw chucks, ...
Requirements which the clamping device must meet:
 Rigid clamping of the workpieces
 No deformation of the workpieces during clamping and milling (weakening of the
workpiece during milling).
 Good repeatability of the clamping process (for more than one part).
 Fast, easy and safe handling.
19.7.7

Feed

Cutter Ø
2 bis 4mm
Tool roughing
HSS 0,004
19.7.8

Cutting speed (guide values)

Material
Steel to 500 N/mm
2
Steel up 500 N/mm 2
Stainless steel 18/10
Aluminum
Brass (CuZn)
HOLZMANN MASCHINEN GmbH
Guide values for the feed in mm per tooth
Cutter Ø
5 bis 8 mm
finishing roughing
0,003 0,03
Tool
end mill
HSS 25 to 35
HSS 15 to 22
HSS 10 to 12
HSS 70 to 90
HSS 50 to 60
www.holzmann-maschinen.at
Cutter Ø
10 bis 25 mm
finishing roughing finishing
0,01 0,1
Cutting speed m/min
shell end mill
25 to 35
15 to 22
10 to 12
70 to 90
60 to 70
OPERTATION
Cutter Ø
25 bis 100 mm
roughing finishing
0,07 0,02
side mill
20 to 25
12 to 15
8 to 10
60 to 70
50 to 60
BF500D | BF500DDRO
0,1
55