Assembly; Scope Of Delivery; Transport / Unloading The Machine - HOLZMANN MASCHINEN FS 160L Mode D'emploi

12

ASSEMBLY

12.1

Scope of delivery

After receipt of the delivery, if all parts are in order. Report any damage or missing items
immediately to your dealer or the shipping company. Visible damage must also be recorded
without delay in accordance with the provisions of the warranty on the delivery, otherwise the
goods shall be accepted as properly.
content:
Milling machine, sliding table, milling hood , Change spindle with 12mm intake, spacer rings 18,
insert rings 2

12.1.1 Transport / unloading the machine

The lifting and transportation of the machine may only be carried out by
qualified personnel are carried out with appropriate equipment.
Note that lifting devices possible used (crane, forklift, sling etc.) must be in perfect condition.
To transport the machine in the packaging to the workplace is best to use a forklift truck (D) or
trucks (F).
In the workplace, remove the packaging and lift the machine to the workplace.
While the lifting of the machine not third parties may persons be in the danger zone!
The machine must be lifted only with correspondingly suitable lifting devices from the packaging.
Prepare to a forklift truck (D) or a manually lifting device (F) before, this and the hoisting ropes
(H) (min. Each 2m long) should min. be approved for the weight of the machine.
Perform two rigid rods through under the machine. Tighten the hoisting ropes on the left and
right under the poles through and hang them in the crane hook, or lead them to the forks of the
forklift.
Lift the machine slightly and check that the load distribution is stable.
HOLZMANN MASCHINEN GmbH
H
www.holzmann-maschinen.at
W A R N I N G
ASSEMBLY
33
FS 160L