Switching On The Machine; Coolant System - HOLZMANN MASCHINEN BF500D Mode D'emploi

OPERTATION
Danger due to electrical voltage! Handling the machine with the power supply up can
lead to serious injuries or even death. Always disconnect the machine from the
power supply before carrying out any adjustment or conversion work and secure
machine it against unintentional reconnection!
Vor jeglichem Werkzeugwechsel Spindel stillsetzen, den Stillstand aller
Maschinenteile abwarten und Maschine gegen unbeabsichtigten Wiederanlauf sichern.

19.1.1 Switching on the machine

Note that the machine can only be started if the EMERGENCY STOP is unlocked, the
chuck guard is closed and all position switches are activated.
19.1.2

Coolant system

HOLZMANN MASCHINEN GmbH
WARNING
CAUTION
NOTICE
To switch on the machine, turn the main switch (1) to
position ON and the speed selector switch horizontal milling
spindle (2) in position "langsam" (slow) or "schnell" (fast).
The main switch of the machine is located on the switch box.
The machine (vertical milling spindle) is started by actuating
the rotation direction button vertical milling spindle left or
right (3).
The machine (horizontal milling spindle) is started by
actuating the rotation direction button horizontal milling
spindle left or right (4).
Press coolant pump ON-button (1) on the control panel. The coolant pump
switches on and pumps the coolant fluid from the coolant tank into the
coolant nozzle.
Press coolant pump OFF-button (2) on the control panel. The coolant
pump switches off.
www.holzmann-maschinen.at
OPERTATION
48
BF500D | BF500DDRO