Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17.1.6
Vertical alignment milling unit
17.1.7
Visual inspection
Supply gear oil (recommended for ISO 12925-1 CKD, DIN51517 Part 3 CLP, US Steel 224, AGMA
9005-E02) with a viscosity of 220.
Check the lubrication of the following parts and top up with suitable oil if necessary before
working on the machine:
Vertical spindle gear
Feed gear
17.1.8 Filling with coolant
High temperatures occur at the cutting edge of the tool due to the frictional heat. The tool should
therefore be cooled during turning. Cooling with a suitable coolant will improve the work result
and prolong the tool life. Therefore, fill with coolant. Use a water-soluble, environmentally
compatible emulsion as coolant, which is available from specialty retailers (e.g. KSM5L).
HOLZMANN MASCHINEN GmbH
The machine head is swivelled for transport and must be
brought into the desired position before start-up.
Loosen (but do not unscrew!) the three hexagon nuts (M) on
the turntable and turn the machine head to the desired
position with the aid of the supplied square wrench (K).
Then retighten the hexagon nuts firmly.
NOTICE
Lubricants are toxic and must not be released into the environment!
Always follow the manufacturer's instructions and, if necessary, contact
your local authority for information on proper disposal.
NOTICE
Coolants are toxic and must not be released into the environment! Follow
the manufacturer's instructions and contact your local authority for
information on proper disposal if necessary. Operating the coolant pump
without coolant in the tank can permanently damage the pump.
www.holzmann-maschinen.at
Make sure that the oil level always reaches the
mark of the sight glass (1). Check the oil level
regularly.
Make sure that the oil level always reaches the
mark of the sight glass (2). Check the oil level
regularly.
ASSEMBLY
45
BF500D | BF500DDRO
Publicité
Table des Matières
