Controller Position; Repair Or Replace A Tire - Quickie 6BC Mode D'emploi

Masquer les pouces Voir aussi pour 6BC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Q UI C KIE PU LS E
6. Armrest angle adjustment
a. Lift the armrest straight up so that it is perpendicular to the floor.
b. Loosen the jam nut (A)
c. Turn the adjusting screw (B) to raise or lower the front of the armrest.
d. Tighten the jam nut (A) to lock the adjusting screw into place.
e. Make sure that the set screws (C), and armrest knob (D) are tight when finished.
Y. CONTROLLER POSITION
You can move the controller in or out in relation to the armrest. You can also move the
controller to either side of your chair to accomodate either left-hand or right-hand use.
Be careful of pinching your controller cords. When the controller is moved, the harness
and cord can be at risk of pinching from the Seat frame, and/or the Power base frame. Be
sure to route and secure the cord with a zip tie to avoid cord pinching,. Cord pinching
could eventually disable your power chair if left unchecked.
1. Extending the controller
a. Flip up the armrest so that it is perpendicular to the floor.
b. Loosen the thumbscrew (E) on the controller bracket.
c. Slide the controller in or out of the armrest to the desired position.
d. Tighten the thumbscrews (E) to secure the controller.
Z. REPAIRING OR REPLACING A TIRE
WARNING
Residual air pressure in tires can cause severe injury. Make sure you release all air in tire
before attempting to service or repair tires.
1. Drive Wheels:
a. Elevate and securely support chair so that wheel is off the ground. Release all air from
tire.
b. Remove the three main lugnuts (F).
c. Remove the Drive wheel/tire assembly
2. Air Tube:
a. To replace the air tube, remove the six hex screws (G) so that the rims can be
seperated.
b. Seperate the two halves of the rim and remove tire and solid insert
f. Repair or replace.
g. Reassemble the wheel. Use a torque setting of 420 in-lbs to re-tighten the bolts.
h. Install the wheel on the chair using a torque setting of 180 in-lbs to retighten the
bolts.
i.
Inflate the tire to the proper pressure level (listed on the tire sidewall)
119832Rev. E
94
95
WARNING
96
XI. DEALER SERVICE & ADJUSTMENT
38
94
95
E
96

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6sc6cc5bc5ccl 6mpc

Table des Matières