O.center Mount Hanger Adjustment; Power Center Mount Footrest Asap; Q.power Center Mount Footrest Recline; Fixed Center Mount Footrest (Power Recline) - Quickie 6BC Mode D'emploi

Q UI C KIE PU LS E
O. CENTER MOUNT HANGER ADJUSTMENT
(ASAP Seating only)
1. Removing the assembly
a. Remove the four screws (A) and slide the footrest assembly out of the receiver.
2. Footplate Height Adjustment
a. Remove the six securing screws (B).
b. Move the footplate up or down to the desired height.
c. Re-install screws (B) through adjusted holes and tighten the hardware.
3. Calf pad Adjustment
a. Remove the two securing screws (C).
b. Move Calf Pads to desired height.
c. Re-install screws (C) through adjusted holes.
P. POWER CENTER MOUNT FOOTREST ASAP
1. Footrest Depth Adjustment (Not recommended)
a. Remove the hardware(D) from the support frame tubes.
b. Move the footrest assembly forward or back for depth adjustments
c. Insert the hardware to lock the adjustment in place.
d. Re-tighten all hardware.
2. Calfpad height, angle and depth adjustment
a. Using a 5mm hex key, loosen both screws(E) and adjust the calfpad to the desired setting.
b. Re-tighten the hardware.
3. Footplate Height Adjustment
a. The footplates (G) can be raised or lowered
b. Using a 5mm hex key loosen the two screws (F) at the top of the footrest bracket, and move
up or down to set the correct height.
c. Re-tighten the hardware to hold the adjustment in place.
Q. POWER CENTER MOUNT FOOTREST RECLINE
1 Calfpad height, angle and depth adjustment
a. Using a 5mm hex key, loosen both screws(E) and adjust the calfpad to the desired setting.
b. Re-tighten the hardware.
2. Powered Footplate Height Adjustment
a. The footplates (G) can be raised or lowered
b. Using a 5mm hex key loosen the two screws (F) at the top of the footrest bracket, and move
up or down to set the correct height.
c. Re-tighten the hardware to hold the adjustment in place.
R. FIXED CENTER MOUNT FOOTREST (POWER RECLINE)
1 Calfpad height, angle and depth adjustment
a. Using a 5mm hex key, loosen both screws(E) and adjust the calfpad to the desired setting.
b. Re-tighten the hardware.
2. Powered Footplate Height Adjustment
a. Using a 5mm hex key, loosen the screws (F) so that the footplates (G) can be raised
or lowered
b. Move the footplates up or down to set the correct height.
c. Re-tighten the hardware to hold the adjustment in place.
119832Rev. E
74
75
76
74 75 76
77
78
79
34
XI. DEALER SERVICE & ADJUSTMENT
74
75
76
77
78
79