Tool Preparation - Rehau RAUTOOL G1 125 Mode D'emploi

RAUTOOL G1 125/160

TOOL PREPARATION

Expansion
The cylinder must be connected directly to the motor via the hydraulic
hose (quick coupling) and the control cable, for the expansion process.
Caution!
Make sure the quick coupling is properly engaged! The coupling may
only be pressurised when it is locked in position!
Check connectors thoroughly for dirt, and clean if
necessary!
The expander set is fully inserted into the cylinder and fi xed in the
cylinder using two short pins and one long pin.
Caution!
Pins should be fully inserted!
The tool may only be operated once the pins are fully inserted
The expander heads 125 or 160 are screwed directly onto the
expander set. For this, the expander heads must be fi tted so that they
are fl at and fully screwed in. Avoid any possible tilting when screwing
the heads in.
23