Miller ArcReach SuitCase 12 Manuel De L'utilisateur page 40

.
Base Selection Of Drive Rolls Upon The Following Recommended Usages:
1. V-Grooved Rolls For Hard Wire.
2. U-Grooved Rolls For Soft And Soft Shelled Cored Wires.
3. U-Cogged Rolls For Extremely Soft Shelled Wires (Usually Hard Surfacing Types).
4. V-Knurled Rolls For Hard Shelled Cored Wires.
5. Drive Roll Types May Be Mixed To Suit Particular Requirements (Example: V-Knurled Roll In Combination With U-Grooved).
Fraction
0.023−0.025 in.
0.030 in.
0.035 in.
0.040 in.
0.045 in.
0.052 in.
1/16 in.
0.035 in.
0.045 in.
0.052 in.
1/16 in.
5/64 in.
0.035 in.
0.045 in.
0.052 in.
1/16 in.
0.068−0.072 in.
0.079 in.
0.045 in.
0.052 in.
1/16 in.
5/64 in.
OM-278792 Page 8
Tableau 8-1. Galet d'entraînement
Wire Diameter
Decimal
0.023−0.025 in.
0.030 in.
0.035 in.
0.040 in.
0.045 in.
0.052 in.
0.062 in.
0.035 in.
0.045 in.
0.052 in.
0.062 in.
0.079 in.
0.035 in.
0.045 in.
0.052 in.
0.062 in.
0.068−0.072 in.
0.079 in.
0.045 in.
0.052 in.
0.062 in.
0.079 in.
Metric Part No.
0.6 mm 087130
0.8 mm 053695
0.9 mm 053700
1.0 mm 053696
1.2 mm 053697
1.3 mm 053698
1.6 mm 053699
0.9 mm 072000
1.2 mm 053701
1.3 mm 053702
1.6 mm 053706
2.0 mm 053704
0.9 mm 132958
1.2 mm 132957
1.3 mm 132956
1.6 mm 132955
1.8 mm 132959
2.0 mm 132960
1.2 mm 083489
1.3 mm 083490
1.6 mm 053708
2.0 mm 053710
Drive Roll (2 Required)
Type
V−Grooved
V−Grooved
V−Grooved
V−Grooved
V−Grooved
V−Grooved
V−Grooved
U−Grooved
U−Grooved
U−Grooved
U−Grooved
U−Grooved
V−Knurled
V−Knurled
V−Knurled
V−Knurled
V−Knurled
V−Knurled
U−Cogged
U−Cogged
U−Cogged
U−Cogged
S-0859