Antari S-500 Mode D'emploi page 9

DMX Operation
Making the DMX Connection – Connect the machine to a DMX controller or to one of the
machines in the DMX chain. The machine uses a 3-pin XLR connector for DMX connection,
the connector is located on the rear of the machine.
Address Setup – Use control menu to set DMX address. The machine occupies 2 control
channels. The starting address is defined as the first channel from which the machine will
respond to the controller. Always double check to make sure there are no overlapping
channles in order to control the machine correctly.
DMX Channel Function
Channel 1
Snow Output Level
Channel 2
Fan Output Level
Pin
1
2
3
DMX Value Range
0 – 5
6 – 255
DMX Value Range
0 – 5
6 – 255
Function
Ground
Data-
Data+
Function
Snow off
Snow Output 1 – 100%
Function
Fan 20%
Fan 21 – 100%
9